The following table describes the settings for TAP Leased Protocol Providers.
|
Setting |
Description |
|
Name |
Name of the service provider. |
|
Description |
Description of the provider. |
|
Maximum Retries |
Number of times to resend a notification before potentially using an alternate service provider; allowable values are from 0 to 10. |
|
Retry interval |
Amount of time in seconds to wait between retries. |
|
Maximum session size |
Number of notifications per connection/session. |
|
Split long message |
Controls whether notifications that exceed the number of characters specified by the Split size setting are split into multiple smaller messages or sent as a single message. |
|
Split size |
Determines the maximum number of characters per message sent to this Protocol Provider. This setting applies only if the Split long message check box is selected. |
|
Maximum message length |
If enforced by this provider, the maximum number of characters allowed per notification. For more information, see Setting Maximum Message Length. |
|
Maximum PIN length |
If enforced by this provider, the maximum number of characters allowed in a PIN. If the PIN is longer than the maximum PIN length, the leading characters are truncated. |
|
Country |
Specifies the Country to associate with this provider. |
|
Baud Rate |
Specifies modem speed to match the paging service provider (many still use 1200 or 2400). |
|
Databits |
Specifies databits to match the paging service provider. |
|
Stopbits |
Specifies stopbits to match the paging service provider. |
|
Parity |
Specifies parity to match the paging service provider (typically even). |
|
Flow Control |
Specifies the flow control between the modem and the serial port (similar to handshaking). |
|
Support CTL |
Specifies whether the service provider supports control characters. |
|
Password |
If required, the password to access the account. |