The following table describes the settings for TAP Protocol Providers.
|
Setting |
Description |
|
Name |
Name of the service provider. |
|
Description |
Description of the provider. |
|
Maximum Retries |
Number of times to resend a notification before potentially using an alternate service provider; allowable values are from 0 to 10. |
|
Retry interval |
Amount of time in seconds to wait between retries. |
|
Maximum session size |
Number of notifications per connection/session. |
|
Split long message |
Controls whether notifications that exceed the number of characters specified by the Split size setting are split into multiple smaller messages or sent as a single message. |
|
Split size |
Determines the maximum number of characters per message sent to this Protocol Provider. This setting applies only if the Split long message check box is selected. |
|
Maximum message length |
If enforced by this provider, the maximum number of characters allowed per notification. For more information, see Setting Maximum Message Length. |
|
Maximum PIN length |
If enforced by this provider, the maximum number of characters allowed in a PIN. If the PIN is longer than the maximum PIN length, the leading characters are truncated. |
|
Country |
Specifies the Country to associate with this provider. |
|
Area Code & Phone Number |
Service provider’s area code and phone number. |
|
Baud Rate |
Specifies modem speed to match the paging service provider (many still use 1200 or 2400). |
|
Databits |
Specifies databits to match the paging service provider. |
|
Stopbits |
Specifies stopbits to match the paging service provider. |
|
Parity |
Specifies parity to match the paging service provider (typically even). |
|
Flow Control |
Specifies the flow control between the modem and the serial port (similar to handshaking). |
|
Support CTL |
Specifies whether the service provider supports control characters. |
|
Password |
If required, the password to access the account. |
|
Init String Override |
Specifies the initialization string for the modem used by this Protocol Provider. If not specified, the provider uses the Init String defined in the Serial Device Resources list on the Resources for Node page. For more information, see . |