Positive Voice Detection

To determine whether a phone is answered by a person or an answering machine, xMatters uses a feature called “Positive Voice Detection” with the Intel Dialogic card to provide data about the length of the salutation, or greeting. The following diagram illustrates a rough time line of the call process:

Positive Voice Detection call process

  1. When xMatters picks up the phone, it listens for a dial tone.
  2. When the dial tone is confirmed, xMatters dials the appropriate phone number.
  3. Assuming there is no error tone, xMatters listens for RINGBACK tone (i.e., the indication that the phone on the other end of the line is ringing), which can be one or more.
  4. When the phone is picked up, xMatters detects the connection.
  5. The salutation (or greeting) is typically a person saying "Hello", or else the voicemail (or answering machine) plays a greeting.
  6. After the salutation, there is a period of silence.

There are some defaults in the system that assist in determining whether the connection has been established with a human or a machine. The following settings can be adjusted on the Phone Device Engine page:

Machine Detection Threshold

This setting compares the salutation section of the above diagram. If the salutation is longer than the Machine Detection Threshold setting, then xMatters results in a “MACHINE DETECT”. If the salutation is shorter, xMatters results in a “VOICE DETECT”. Both of these values are tested in the default voice scripts so they can branch accordingly. (Default setting is “2” seconds.)

Low2Ring Minimum

This value is the minimum long low duration of double ring, in milliseconds. This setting should be used in areas such as the United Kingdom, for double rings on the RINGBACK tone. (Default setting is “2250”, or 2.25 seconds.)

Maximum Answer

This value is the maximum allowable length of a salutation, in 10ms units. If this value is reached during a salutation, the system will assume a connection with a machine, and continue with the script. (Default setting is “1000”, or 10 seconds.)

Required Prompt Silence

After the salutation is complete, xMatters waits for the length of time specified by this setting before beginning to speak (or leave a message). (Default setting is “1500” in milliseconds, or 1.5 seconds.)

Note that making this parameter too short can cause problems. For example, if you set this value to 50 (half of a second) and the person’s voicemail greeting has a half-second pause in the middle, xMatters will start leaving a message before the greeting is complete. In some environments, this setting may work better with a one-second delay, while other configurations may require two seconds.