PUCP Protocol Providers

The following table describes the settings for PUCP Protocol Providers.

PUCP Provider Details

Setting

Description

Name

Name of the protocol provider.

Description

A brief description of the provider (optional).

Maximum Retries

Number of times to resend a notification before potentially using an alternate service provider; allowable values are from 0 to 10.

Retry Interval

Amount of time in seconds to wait between retries.

Maximum session size

Number of notifications per connection/session.

Split long message

Controls whether notifications that exceed the number of characters specified by the Split size setting are split into multiple smaller messages or sent as a single message.

Split size

Determines the maximum number of characters per message sent to this Protocol Provider. This setting applies only if the Split long message check box is selected.

Maximum message length

If enforced by this provider, the maximum number of characters allowed per notification. For more information, see Setting Maximum Message Length.

Maximum PIN length

If enforced by this provider, the maximum number of characters allowed in a PIN. If the PIN is longer than the maximum PIN length, the leading characters are truncated.

Originator

Code identifying the message source to the protocol provider.

User Name

User name, if required by your service provider.

Password

Password, if required by your service provider.

Country

Specifies the Country to associate with this provider.

Area Code

Service provider’s area code.

Phone Number

Service provider’s phone number.

UCP Level

UCP operation level required by the service provider; the default setting of “01” is implemented for legacy operations.

Encoded

Select the method used to encode messages sent to the service provider: ENCODE_GSM will encode messages using GSM 7-bits encoding, and ENCODE_HEX will encode messages using an ASCII-based hex protocol.

Baud Rate

Specifies modem speed to match the paging service provider (many still use 1200 or 2400).

Databits

Specifies databits to match the paging service provider.

Stopbits

Specifies stopbits to match the paging service provider.

Parity

Specifies parity to match the paging service provider (typically even).

Flow Control

Specifies the flow control between the modem and the serial port (similar to handshaking).

Init String Override

Specifies the initialization string for the modem used by this Protocol Provider. If not specified, the provider uses the Init String defined in the Serial Device Resources list on the Resources for Node page. For more information, see .