The following table describes the settings for DTMF Protocol Providers.
|
Setting |
Description |
|
Name |
Name of the protocol provider. |
|
Description |
A brief description of the provider (optional). |
|
Maximum retries |
Number of times to resend a notification before potentially using an alternate service provider; allowable values are from 0 to 10. |
|
Retry interval |
Amount of time in seconds to wait between retries. |
|
Maximum session size |
Number of notifications per connection/session. |
|
Split long message |
Controls whether notifications that exceed the number of characters specified by the Split size setting are split into multiple smaller messages or sent as a single message. |
|
Split size |
Determines the maximum number of characters per message sent to this Protocol Provider. This setting applies only if the Split long message check box is selected. |
|
Maximum message length |
If enforced by this provider, the maximum number of characters allowed per notification. For more information, see Setting Maximum Message Length. |
|
Maximum PIN length |
If enforced by this provider, the maximum number of characters allowed in a PIN. If the PIN is longer than the maximum PIN length, the leading characters are truncated. |
|
Country |
Specifies the Country to associate with this provider. |
|
Area Code |
Service provider’s area code. |
|
Phone Number |
Server phone number (prefixed with country and area code). |
|
Call center phone |
Indicates whether the service provider uses a call center. |
|
Wait time between phone and PIN and/or PIN and message (sec) |
When the service provider uses a call center, this specifies the amount of time in seconds to pause between either phone and PIN, or PIN and message. |
|
Wait finish timeout |
When the service provider uses a call center, this specifies the amount of time in seconds to pause before timing out the session. |
|
Init String Override |
Specifies the initialization string for the modem used by this Protocol Provider. If not specified, the provider uses the Init String defined in the Serial Device Resources list on the Resources for Node page. For more information, see . |